In Stock
£12.86
Ex Tax: £12.86
-
+

Description

  • Perfect for converting a bottle into a light fitting.
  • For bottle hole size 19-21mm. (UK Made)
  • Black 3 core cable with UK plug and inline switch.
  • Chrome BC, B22, Bayonet Cap Lampholder. (UK Made)
  • BOTTLE NOT INCLUDED

Product description

Bottle Lamp Kit with Black cable with inline switch, rubber bung and a chrome lampholder. This kit has a 19-21mm so ensure the hole in the bottle is in between these two measurements. This kit 21 is intended to have the flex run into the bottle and a 10mm hole is required to be drilled. We then supply a plastic grommet for this hole. So once the hole is drilled and the grommet inserted. Feed the flex into the bottle and up out the neck. Add the strain relief onto the flex so it is set just behind the entry hole and taking the strain off the lampholder connections. Then hand tighten the bung so it is a tight fit when pushed into the neck with the flex now coming out the top. With a spanner tighten the bung so it grips the bottle. Add the lampholder and you are all done. Gin bottle not included. Mains lead length is 2.5m in total and the switch is a minimum of 800mm from the un-wired end. Lampholder takes a standard BC light bulb. Check out our other bung sizes and colour options on our other listings. Tip: If you have a 22mm hole you can put an elastic band around the rubber bung to make it wider. Please note: These bungs will not tighten up extremely tight as they are rubber, however if installed correctly you wont have any issues with wobble, if its not tightening up enough you can use glue.
Item Weight
Batteries required No
ASIN B072LJV9T2
Manufacturer reference PLU1487
Date First Available 11 May 2017

Reviews (0)

Write a review

Note: HTML is not translated!
    Bad           Good